interference fit

单词interference fit

基本解释

un.: 干涉配合；静配合；压配合
网络: 经配合

英汉解释

• 压配合

• 静配合

• 干涉配合

例句

• Bearings with a tapered bore are always mounted with an interference fit .

  带圆锥孔轴承始终以过盈配合安装。

• For bearings having a tapered bore , inner rings are always mounted with an interference fit .

  对于圆锥孔轴承，内圈的安装始终采用过盈配合。

• The mating surface of the rod and bearing cap form a rough surface (interference fit) that eliminates the need for centering sleeves.

  该杆和轴承盖形成粗糙的表面（盈），减少了对中心袖子需要交配的表面。

• Interference fit is required between outer ring and housing as the load is varying in direction relative to the outer ring.

  外圈与轴承座之间需要过盈配合，因为相对于外圈的负荷方向有变化。

• This paper deals with designed theory and method for interference fit between plastic shaft and plastic hub.

  陈述了塑料实芯轴与孔座间过盈连接的设计理论和方法。

• The planet gear shafts and the axis holes of the planet gears are connected under an interference fit.

  行星齿轮轴与行星齿轮的轴孔之间为过盈配合。

• Alignment needle roller bearings should have an interference fit in the housing bore.

  对中滚针轴承的轴承座孔应过盈配合。

• We can accurately pick out the interference fit we need by using the two choosing ways above mentioned comprehensively.

  通过上述两种选择方法的综合运用，能够准确合理地选择所需的过盈配合。

• Therefore, the ring need not necessarily have an interference fit unless this is required for other reasons.

  因此，轴承圈不一定要有过盈配合，除非因其它原因需要这样做。

• Oil pressure dismounting interference fit and its application iri compressor

  油压法拆装的过盈配合及其在压缩机中的应用